BOOST WIFI ANTENNA SIGNAL STRENGTH
Not only is this clever use of a beer can or Pepsi tin pack an ultra cheap tech hack, it also means less fiddling around with cardboard and aluminum foil as required by other hack methods. This method has been proven to improve Wi-Fi reception from around 2 bars to about 4 on average, varying between 3 and 5. Give it a go – all you've got to waste is a beer can!
1:- Gather the required materials and tools. These are listed below under "Things You'll Need"
2:- Clean the beer can or pepsi tin pack. Make sure there is no residue left inside.
3.Take the ring-pull off the can.
4:- Cut the end off the beer can where there's no opening. Do this using the Stanley knife or similar
suitable safety knife
5:- Cut around the end with the opening almost all the way. Leave a little bit of metal to keep
attached the part that will be the base (see the white line in the illustration)
6:- Cut along the middle of the can in a straight line, opposite to the piece of metal attaching
the base.
7:- Being careful, open up the middle piece of metal by bending it until it vaguely resembles the
shape of a radar dish.
8:- Place the completed Wi-Fi booster on your router. Place it so that the antenna pokes through the
opening, and stick the base of the can to the router with a small piece of poster tack or other suitable
adhesive. It's time to test how much your Wi-Fi is now boosted!
